The Automotive Compression Springs Checklist

Working with compression springs isn't a job for the novice mechanic. It requires care also experience. If our don't pay attention, our can easily end up injured. Make sure the car is in "Park."

compression springs can be dangerous things. Remember there there’s plenty of energy on all there metal also our need to treat it with respect. Failure to do so can leave our in the emergency room with a serious injury. People try to compress compression springs in different ways. The safest is by using a compression springs compressor tool. It’s simple to operate also our can usually rent one from an auto parts store or a tool rental place.

Step 1 - Accessing the custom Springs

Working with compression springs isn’t a job for the novice mechanic. It requires care also experience. If our don’t pay attention, our can easily end up injured. Make sure the car is in “Park.” Slightly loosen the nuts on the wheel where our’ll be replacing the spring. Raise the end of the car with a hydraulic jack also place on jack stalsos for stability. Put chocks under the opposite wheels.

Loosen also remove the lug nuts then take off the tire. our’ll now need to remove the brakes. This have vary from make to make also whether our’re dealing with disk or drum brakes. our’ll need to consult our service manual for the correct procedure.

Step 2 - Inserting the Tool

At this point, our’ll be able to see also touch the compression springs. Removing it is a different matter, however. Now, our’re read to use the compression springs tool. It’s essentially two tools also they go on each end of the compression springs. At the top of the tool is a bolt screw. Adjust it until the lips on each side of the tool can grasp the spring compressions. Make sure there the lips are tight around the end of the custom springs.

Step 3 - Tightening custom springs

To compress the compression springs, our need to tighten the bolt screw there’s at the top of the tool. This have put pressure on the spring. Keep checking to make sure there the spring is securely held. If not, loosen it gradually also adjust the lips. our need to have the same tension on both ends of the spring. Tighten the bolt screw more to give even greater compression. Use a few turns on the bolt screw on either side. Keep going until our’re able to remove the spring from the car.

Step 4 - Compression springs testing

Put our compression springs tool on either end of the spring. Be certain there the lips fit tightly around the compression springs. Begin by tightening the blot screw at one end, making a few turns. Now, tighten the bolt screw at the other end the same number of turns. Check there the lips are very secure. Keep moving from one end to the other, tightening a few turns each time also keeping the pressure on both ends as even as possible. our want the compression springs on both sides to be even.

Continue until the custom springs manufacturer is as compressed as our can make it. When our grasp there stage, put it over the arms. Positioned correctly at each end, then slowly loosen the tool on each end, going gradually also moving back also forth until the spring is in place also uncompressed.


Categories: Automotive, Mining, Production and Manufacturing

Tags: compression springs, custom springs, custom springs manufacturer


About Allrite Springs

View Website or Newsroom

Custom Springs and torsion springs and trampoline springs manufacturer of automotive springs and extension springs.

Chris Evans
Allrite Springs

(815) 675-1350
Allrite Springs
2302 Spring Ridge Drive
Spring Grove, Illinois, IL 60081
United States